Build the ultimate arcade here in San Diego filled with classic arcades and pinball machines.
But I suspect that isn’t a surprise to anyone reading this. 😉
Comet is one of two non functional pinball machines I picked up for at a Garage Sale about two months ago. The other is Space Station (whose repair log is here).
Battery corrosion — but no leaks.
- All displays are dead.
- Display Power Supply voltage problem.
- All ramps are damaged to some degree. The middle ramp needs repair.
[7/13] Removed corroded battery holder and replaced it with an off-board battery holder. Game powered up and played very well (except of course for the lack of displays, and middle ramp issue). Luckily the corrosion does not appear to have spread.
All displays are dead.
- [7/13] The glass looks scorched. Will have to see if any of the displays work after I repair the voltage problem. I suspect I will end up having to purchase a new set of LED displays.
Display Power Supply voltage problem.
- [7/17] 100 volts was missing on one of the two 100v pins. When I was feeling around for overheated components, I touched the heat sink of one of the transistors and got a little zap! Since the heat sinks of a transistor should be ground, I believe someone hooked up a replacement transistor without making sure the correct leg went in the correct hole (often replacement transistors legs are in a different order than the original component).
Ramp Damage: Middle / Roller Coaster Ramp
- [7/15] Side walls at entrance appear to have melted slightly and lean far to the right. This prevents the entry gate/switch from moving out of the way of the ball. With gate removed, a large bump at the entrance still makes entry almost impossible and causes many airballs to fly hard into the glass.
- [7/16] After talking it over with several people, and doing some reading, we will probably use a heat source to soften the ramp enough to allow us to reposition the warped walls… and perhaps lower the bump. Per the suggestion of both Shane and my father-in-law, we may attempt to use some kid of resin to reattach the cracked lip at the very front of the ramp.
Space Station is one of two non functional pinball machines I picked up for at a Garage Sale about two months ago (the other is Comet). I decided to start with this one because it is at least partially playable. 🙂
Here is a list of issues I have discovered.
- Player 3 Display is out.
- Display Power Supply voltage problem (+/- 100v = 120v/-130v).
- Left Dock Kicker (does not kick).
- Top Pop Bumper (does not bump).
- 2 balls get kicked into the launch bay (at the same time).
- Right Flipper is sloppy.
- Right Dock gate installed backwards (not allowing the ball to escape).
- Stuck switches (x 5).
- Rubbers need replacing.
- Plunger power barely/not always enough to get ball to top of playfield.
Player 3 Display / Power Supply voltage problem
[6/20] I believe I will need to rebuild the +/-100v section of the display power board. If the missing display functionality is not restored, with the correct voltage applied I will have to buy a new display (e.g. Pinball Life).
Left Dock Kicker
[6/22] Coil gets 80v of power; does not fire in “coil test” mode nor “in game”; further coil would not fire when shorting to ground. I removed the coil, and it has continuity to both solder points, and it tests at about 4.2 ohms of resistance. I don’t know if the coil is bad or not, but I suspect it is bad.
Top Pop Bumper